Recommended for well-draining roofing surfaces only (see Warranty Compliance Below). Excellent adhesion on concrete tiles, clay tiles, masonry tiles (flat or barrel), adobe, slate, slab and various other substrates. PERMAGLAZE™is ideal for residential, commercial and industrial applications.
Not recommended for use on metal surfaces. Check out our elastomeric roof coating for a longer lasting product on tile or for other roof substrates such as metal or shingle roofs PERMAGARD® Roof Coating. For flat roofs or limited ponding water situations inquire about PERMAKOTE PLUS® Flat Roof Coating, Limited Ponding Water Roof Coating.

SURFACE PREPARATION:
Apply only to a sound, completely dry, well prepared roof surface. Leaks must be repaired before any coating is applied. If primer was applied, it is essential that the primer surface is clean and dry and free of all moisture. If no primer was applied, prepare surface by thoroughly pressure washing with a water and chlorine mixture using at least 1500 P.S.I. to remove any previous coatings, dirt, grease, and other foreign materials, especially mold, mildew and algae.
PERMAGLAZE™ will resist mildew growth but will not kill mildew already on the surface. Use SUPER BOND™ Primer on smooth non-porous surfaces prior to PERMAGLAZE™ tile roof paint.

APPLICATION PROCEDURE:
Stir well before using. Do not thin, use product as is. Mix multiple containers of color together for greater color consistency. Do not apply when temperatures are below 45 degrees Fahrenheit or when humidity is very high. Do not apply when coating will be subjected to rain or heavy dew before it has had enough time to dry (approx. 2 to 4 hours). Drying time will vary depending on temperature, humidity and location. Apply using brush, roller or spray. Spread coating uniformly. Spread Rate will vary depending on surface. Apply each coat between 5 to 7 mils wet film thickness. Wait at least 2 hours before applying a second coat. Two coats resulting in a minimum 5 mil total dry film thickness is required
Airless Sprayers: Use a 1 gallon per minute piston type airless sprayer with a tip size of .015 to .017.

Clean Up:
Clean up all spills, tools and overspray immediately while the coating is still wet with warm soapy water.